read_measureT_read_measureReadMeasureReadMeasure (Operator)

Name

read_measureT_read_measureReadMeasureReadMeasure — Read a measure object from a file.

Signature

read_measure( : : FileName : MeasureHandle)

Description

read_measureread_measureReadMeasureReadMeasureReadMeasure reads a measure object, which has been written with write_measurewrite_measureWriteMeasureWriteMeasureWriteMeasure from the file FileNameFileNameFileNameFileNamefileName. The default HALCON file extension for a measure object is 'msr'. The values contained in the read measure object are stored in a measure object with the handle MeasureHandleMeasureHandleMeasureHandleMeasureHandlemeasureHandle.

For an explanation of the concept of 1D measuring see the introduction of chapter 1D Measuring.

Execution Information

Multithreading type: reentrant (runs in parallel with non-exclusive operators).
Multithreading scope: global (may be called from any thread).
Processed without parallelization.

This operator returns a handle. Note that the state of an instance of this handle type may be changed by specific operators even though the handle is used as an input parameter by those operators.

Parameters

FileNameFileNameFileNameFileNamefileName (input_control) filename.read → (string)

File name.

File extension: .msr

MeasureHandleMeasureHandleMeasureHandleMeasureHandlemeasureHandle (output_control) measure → (handle)

Measure object handle.

Result

If the parameters are valid, the operator read_measureread_measureReadMeasureReadMeasureReadMeasure returns the value 2 (H_MSG_TRUE). If necessary, an exception is raised.

Possible Successors

measure_posmeasure_posMeasurePosMeasurePosMeasurePos, measure_pairsmeasure_pairsMeasurePairsMeasurePairsMeasurePairs

Module

1D Metrology

Operators