tuple_split — Split strings into substrings using predefined separator symbol(s).
tuple_split( : : String, Separator : Substrings)
tuple_split searches within the strings of the input tuple
String for the separators defined in the input tuple
Separator.
tuple_split then splits the examined strings into
the substrings divided by the separators and returns them in the
tuple Substrings.
The behavior depends on the length of the input tuples:
Separator contains only one string:
Every string in String is split up according to the
separator symbols in Separator.
E.g., String = ['alpha:1', 'beta:2', 'gamma:3']
and Separator = ['a:'].
In this case, the operator returns the tuple Substrings =
['lph', '1', 'bet', '2', 'g', 'mm', '3'].
String contains only one string:
The single string is split up for every element in Separator.
E.g., String = ['alpha:1 beta:2 gamma:3'] and
Separator = [':', '123']. In this case, the output
tuple Substrings will comprise the substrings
'alpha', '1', 'beta', '2',
'gamma', and '3', as the result of splitting the string
of String according to the first element of Separator
(':') as well as 'alpha:', 'beta:', and
'gamma:' as the result of splitting according to the second
element of Separator ('123').
Both tuples consist of the same amount of strings:
The search is done elementwise.
I.e., tuple_split will split the first string of String
according to the separator symbols in the first element of
Separator, the second string of String according to the
separator symbols in the second element of Separator and so on.
Either or both of the input tuples are empty: An empty tuple is returned.
Notes to Separator:
If an element of Separator contains more than one character,
each character defines a separator (see the example given above).
Subsequent occurrences of Separator in String are
treated as one separator.
Separators at the beginning and the end of String will not
result in an empty string.
Please consider, both input tuples (String and Separator)
may only consist of strings. Otherwise tuple_split returns an error.
If both input tuples contain more than one element and the number of
elements differs for the input tuples, tuple_split returns an error.
The split characters are interpreted as Unicode code points. One Unicode
code point may be composed of multiple bytes in the UTF-8 string.
If the split characters should be handled as raw bytes of the string, this
operator can be switched to byte mode with
set_system('tsp_tuple_string_operator_mode', 'byte').
If 'filename_encoding' is set to 'locale' (legacy), this
operator always uses the byte mode.
For general information about string operations see Tuple / String Operations.
HDevelop provides an in-line operation for tuple_split,
which can be used in an expression in the following syntax:
Substrings := split(String, Separator)
String (input_control) string(-array) → (string)
Input tuple with string(s) to split.
Separator (input_control) string(-array) → (string)
Input tuple with separator symbol(s).
Substrings (output_control) string(-array) → (string)
Substrings after splitting the input strings.
tuple_strstr,
tuple_strrstr,
tuple_strchr,
tuple_strrchr,
tuple_strlen,
tuple_str_first_n,
tuple_str_last_n,
tuple_environment
Foundation