get_shape_model_3d_contours — Return the contour representation of a 3D shape model view.
get_shape_model_3d_contours( : ModelContours : ShapeModel3DID, Level, View : ViewPose)
The operator get_shape_model_3d_contours returns a
representation of a single model view of the 3D shape model
ShapeModel3DID as XLD contours in ModelContours.
The parameters Level and View determine for which
model view the contour representation should be returned, where
Level denotes the pyramid level and View denotes
the model view on this pyramid level.
The permitted range of values for Level and View
can previously be determined by using the operator
get_shape_model_3d_params and passing
'num_views_per_level' for GenParamName.
The contours can be used to visualize and rate the 3D shape model
that was created with create_shape_model_3d. With this it is
possible, for example, to decide whether the number of pyramid
levels in the model is appropriate or not. If the contours on the
highest pyramid do not show enough details to be representative for
the model view, the number of pyramid levels that are used during
the search with find_shape_model_3d should be adjusted
downwards. In contrast, if the contours show too many details even
on the highest pyramid level, a higher number of pyramid levels
should be chosen already during the creation of the 3D shape model
by using create_shape_model_3d.
Additionally, the pose of the selected view is returned in
ViewPose. It can be used, for example, to project the 3D
shape model according to the view pose by using
project_shape_model_3d. The rating of the model contours
that was described above can then be performed by comparing the
ModelContours to the projected model. Note that the
position of the contours of the projection and the position of the
model contours may slightly differ because of radial distortions.
ModelContours (output_object) xld_cont-array → object
Contour representation of the model view.
ShapeModel3DID (input_control) shape_model_3d → (handle)
Handle of the 3D shape model.
Level (input_control) integer → (integer)
Pyramid level for which the contour representation should be returned.
Default value: 1
Suggested values: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
Restriction: Level >= 1
View (input_control) integer → (integer)
View for which the contour representation should be returned.
Default value: 1
Suggested values: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
Restriction: View >= 1
ViewPose (output_control) pose → (real / integer)
3D pose of the 3D shape model at the current view.
If the parameters are valid, the operator
get_shape_model_3d_contours returns the value 2 (H_MSG_TRUE). If
necessary an exception is raised.
create_shape_model_3d,
read_shape_model_3d,
get_shape_model_3d_params
3D Metrology