sfs_orig_lr — Reconstruct a surface from a gray value image.
sfs_orig_lr reconstructs a surface (i.e. the relative
height of each image point) using the original algorithm of Lee and
Rosenfeld. The surface is reconstructed from the input image
Image. The light source is to be given by the parameters
Slant, Tilt, Albedo and
Ambient, and is assumed to lie infinitely far away in the
direction given by Slant and Tilt. The
parameter Albedo determines the albedo of the surface,
i.e. the percentage of light reflected in all directions.
Ambient determines the amount of ambient light falling
onto the surface. It can be set to values greater than zero if, for
example, the white balance of the camera was badly adjusted at the
moment the image was taken.
sfs_orig_lr assumes that the heights are to be extracted on
a lattice with step width 1. If this is not the case, the
calculated heights must be multiplied with the step width after the
call to sfs_orig_lr. A Cartesian coordinate system with the
origin in the lower left corner of the image is used internally.
sfs_orig_lr can only handle byte-images.
Image (input_object) singlechannelimage(-array) → object (byte)
Shaded input image.
Height (output_object) image(-array) → object (real)
Reconstructed height field.
Slant (input_control) angle.deg → (real / integer)
Angle between the light source and the positive z-axis (in degrees).
Default value: 45.0
Suggested values: 1.0, 5.0, 10.0, 20.0, 40.0, 60.0, 90.0
Typical range of values: 0.0
≤
Slant
≤
90.0
Minimum increment: 0.01
Recommended increment: 10.0
Tilt (input_control) angle.deg → (real / integer)
Angle between the light source and the x-axis after projection into the xy-plane (in degrees).
Default value: 45.0
Suggested values: 1.0, 5.0, 10.0, 20.0, 40.0, 60.0, 90.0
Typical range of values: 0.0
≤
Tilt
≤
360.0
Minimum increment: 0.01
Recommended increment: 10.0
Albedo (input_control) number → (real / integer)
Amount of light reflected by the surface.
Default value: 1.0
Suggested values: 0.1, 0.5, 1.0, 5.0
Typical range of values: 0.0
≤
Albedo
≤
5.0 (lin)
Minimum increment: 0.01
Recommended increment: 0.1
Restriction: Albedo >= 0.0
Ambient (input_control) number → (real / integer)
Amount of ambient light.
Default value: 0.0
Suggested values: 0.1, 0.5, 1.0
Typical range of values: 0.0
≤
Ambient
≤
1.0 (lin)
Minimum increment: 0.01
Recommended increment: 0.1
Restriction: Ambient >= 0.0
If all parameters are correct sfs_orig_lr returns the
value TRUE. Otherwise, an exception is raised.
estimate_al_am,
estimate_sl_al_lr,
estimate_sl_al_zc,
estimate_tilt_lr,
estimate_tilt_zc,
optimize_fft_speed
3D Metrology