create_metrology_modelT_create_metrology_modelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model (Operator)

Name

create_metrology_modelT_create_metrology_modelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model — Create the data structure that is needed to measure geometric shapes.

Signature

create_metrology_model( : : : MetrologyHandle)

Description

create_metrology_modelcreate_metrology_modelCreateMetrologyModelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model creates a metrology model, i.e., the data structure that is needed to measure objects with a specific geometric shape (metrology object) via 2D metrology, and returns it in the handle MetrologyHandleMetrologyHandleMetrologyHandleMetrologyHandlemetrologyHandlemetrology_handle.

For an explanation of the concept of 2D metrology see the introduction of chapter 2D Metrology.

Attention

Note, that after calling the operator create_metrology_modelcreate_metrology_modelCreateMetrologyModelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model the operator set_metrology_model_image_sizeset_metrology_model_image_sizeSetMetrologyModelImageSizeSetMetrologyModelImageSizeSetMetrologyModelImageSizeset_metrology_model_image_size should be called for efficiency reasons.

Execution Information

Multithreading type: reentrant (runs in parallel with non-exclusive operators).
Multithreading scope: global (may be called from any thread).
Processed without parallelization.

This operator returns a handle. Note that the state of an instance of this handle type may be changed by specific operators even though the handle is used as an input parameter by those operators.

Parameters

MetrologyHandleMetrologyHandleMetrologyHandleMetrologyHandlemetrologyHandlemetrology_handle (output_control) metrology_model → (handle)

Handle of the metrology model.

Example (HDevelop)

read_image (Image, 'fabrik')
create_metrology_model (MetrologyHandle)
get_image_size (Image, Width, Height)
set_metrology_model_image_size (MetrologyHandle, Width, Height)
add_metrology_object_rectangle2_measure (MetrologyHandle, 270, 230, 0, 30, \
                                  25, 10, 2, 1, 30, [], [], Index)
apply_metrology_model (Image, MetrologyHandle)
get_metrology_object_result (MetrologyHandle, Index, 'all', 'result_type', \
                      'all_param', Rectangle)
get_metrology_object_result_contour (Contour, MetrologyHandle, \
                                    Index, 'all', 1.5)

Result

If the parameters are valid, the operator create_metrology_modelcreate_metrology_modelCreateMetrologyModelCreateMetrologyModelCreateMetrologyModelcreate_metrology_model returns the value 2 (H_MSG_TRUE). If necessary, an exception is raised.

Possible Successors

set_metrology_model_image_sizeset_metrology_model_image_sizeSetMetrologyModelImageSizeSetMetrologyModelImageSizeSetMetrologyModelImageSizeset_metrology_model_image_size

Module

2D Metrology

Operators