get_sheet_of_light_result_object_model_3d — Get the result of a calibrated measurement performed with the
sheet-of-light technique as a 3D object model.
get_sheet_of_light_result_object_model_3d( : : SheetOfLightModelID : ObjectModel3D)
The operator get_sheet_of_light_result_object_model_3d returns the
result of a fully calibrated sheet-of-light measurement as a 3D object
model. The handle of the sheet-of-light model with which the
measurement is performed must be passed to SheetOfLightModelID.
The calibration extent of the sheet-of-light model ('calibration')
must have been set to 'xyz' or 'offset_scale'
before applying the measurement,
otherwise the computed coordinates cannot be returned as a 3D object model
and an exception is raised.
The handle of the 3D object model resulting from the measurement is returned
in ObjectModel3D. For the 3D points within this 3D object model
no triangular meshing is available, therefore no faces are stored in the 3D
object model. If a 3D object model with triangular meshing is required for
the subsequent processing, use the operator get_sheet_of_light_result
in order to retrieve the 'x', 'y', and 'z'
coordinates from the sheet-of-light model and then call the operator
xyz_to_object_model_3d with suitable parameters. Refer to
xyz_to_object_model_3d for more information about 3D object models.
The unit of the returned coordinates depends on the value of the parameter
'scale' that was set for the sheet-of-light model before applying
the measurement.
See create_sheet_of_light_model and set_sheet_of_light_param
for details on the possible values of the model parameter 'scale'.
The operator get_sheet_of_light_result_object_model_3d returns a
handle to an empty 3D object model if the desired result has not been
measured yet.
This operator returns a handle. Note that the state of an instance of this handle type may be changed by specific operators even though the handle is used as an input parameter by those operators.
SheetOfLightModelID (input_control) sheet_of_light_model → (handle)
Handle for accessing the sheet-of-light model.
ObjectModel3D (output_control) object_model_3d → (handle)
Handle of the resulting 3D object model.
The operator get_sheet_of_light_result_object_model_3d returns the
value 2 (
H_MSG_TRUE)
if the given parameters are correct.
Otherwise, an exception will be raised.
create_sheet_of_light_model,
measure_profile_sheet_of_light,
calibrate_sheet_of_light
3D Metrology