| Operators |
close_edges — Close edge gaps using the edge amplitude image.
close_edges(Edges, EdgeImage : RegionResult : MinAmplitude : )
close_edges closes gaps in the output of an edge detector, and thus tries to produce complete object contours. This is done by examining the neighbors of each edge point to determine the point with maximum amplitude (i.e., maximum gradient), and adding the point to the edge if its amplitude is larger than the minimum amplitude passed in MinAmplitude. This operator expects as input the edges (Edges) and amplitude image (EdgeImage) returned by typical edge operators, such as edges_image or sobel_amp. close_edges does not take into account the edge directions that may be returned by an edge operator. Thus, in areas where the gradient is almost constant the edges may become rather “wiggly.”
Note that filter operators may return unexpected results if an image with a reduced domain is used as input. Please refer to the chapter Filters.
Region containing one pixel thick edges.
Edge amplitude (gradient) image.
Region containing closed edges.
Minimum edge amplitude.
Default value: 16
Suggested values: 5, 8, 10, 12, 16, 20, 25, 30, 40, 50
Typical range of values: 1 ≤ MinAmplitude ≤ 255
Minimum increment: 1
Recommended increment: 1
Restriction: MinAmplitude >= 0
sobel_amp(Image,&EdgeAmp,"sum_abs",5); threshold(EdgeAmp,&EdgeRegion,40.0,255.0); skeleton(EdgeRegion,&ThinEdge); close_edges(ThinEdge,EdgeAmp,&CloseEdges,15); skeleton(CloseEdges,&ThinCloseEdges);
close_edges returns 2 (H_MSG_TRUE) if all parameters are correct. If the input is empty the behavior can be set via set_system('no_object_result',<Result>). If necessary, an exception is raised.
edges_image, sobel_amp, threshold, skeleton
close_edges_length, dilation1, closing
Foundation
| Operators |